SW2 L4-1.9L DOHC VIN 7 (1997)
CAUTION: After the front cover is installed, 6-12 squirts of oil should be pumped through the front oil seal drain back hole to make sure it is not
plugged.
6. Apply RTV across the cylinder head and front cover "T" joints. The cam cover gasket can be reused if not damaged. Install the cam cover
assembly and tighten the fasteners uniformly. Torque to 10 Nm (89 inch lbs.).
CAUTION: Inspect the cam cover isolators for cracks. Replace the isolators if deterioration exist.
7. Install water pump pulley, if removed. Torque to 25 Nm (19 ft. lbs.).
CAUTION: Install a thin film of RTV sealant P/N 21006236 between the damper/pulley assembly flange and washer only. The washer and bolt
head flange are designed to prevent oil leakage and do not require RTV sealant.
