SW2 L4-1.9L DOHC VIN 7 (1997)
6. Lower liquid line past wiring harness and hood release cable.
7. Lower hood support rod.
a. Move receiver drier end of line around hood support rod and fuse box.
CAUTION: Do not bend line around hood support rod. After lowering rod, gently flex line around the radiator core support.
b. Insert drier end of line through body cut out.
IMPORTANT: Install liquid line in front clamp located just behind the pressure switch.
8. Remove tape and protective cover from TXV end of liquid line.
NOTICE: Use only R-12 Refrigerant oil (mineral) to lubricate O-rings. Use of R-134a (PAG) oil will cause premature corrosion of fitting joints.
