SW2 L4-1.9L DOHC VIN 7 (1997)
-
Torque: 165 Nm (122 ft. lbs.)
IMPORTANT: With strut-to-knuckle fasteners installed but not tightened, push bottom of strut inward while tightening fasteners.
7. Torque strut-to-knuckle fasteners.
-
Torque: 170 Nm (126 ft. lbs.)
8. Join hub, brake backing plate, and knuckle with four fasteners. Torque to specifications.
-
Torque: 85 Nm (63 ft. lbs.)
9. Install brake rotor.
10. Install caliper onto knuckle and secure with two fasteners.
-
Torque: 85 Nm (63 ft. lbs.)
11. Install electrical connector to ABS wheel speed sensor.
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel lug nuts to loosen in service.
12. Position wheel onto hub.
13. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to make sure torque is correct.
-
Torque: 140 Nm (103 ft. lbs.)
14. Lower vehicle from hoist.
15. Perform vehicle wheel alignment. (Refer to Alignment.)