VUE 2WD V6-3.5L VIN 4 (2004)
3. Remove the caps from the master cylinder brake pipe ends.
4. Remove the plugs from the master cylinder ports on the modulator assembly.
5. Connect the master cylinder brake pipes to the modulator assembly, in the same location as removed.
6. Tighten the brake pipe fittings at the brake pressure modulator valve (BPMV).
^
Tighten the fittings to 18 Nm (13 ft. lbs.).
7. Remove the caps from the caliper and wheel cylinder brake pipe ends.
8. Remove the plugs from the caliper and wheel cylinder ports on the modulator assembly.
9. Connect the caliper and wheel cylinder brake pipes to the modulator assembly, in the same location as removed.
10. Tighten the brake pipe fittings at the BPMV.
^
Tighten the fittings to 18 Nm (13 ft. lbs.).
11. Connect the electrical connector to the EBCM.
12. Reposition the TCM, if equipped, to the mounting bracket.
13. Bleed the hydraulic brake system.
14. Turn the ignition switch to the ON position. DO NOT start engine.
15. Perform the Diagnostic System Check - ABS.
16. Observe the feel of the brake pedal after performing the diagnostic system check. If the pedal now feels spongy, air may have been in the
