VUE AWD L4-2.2L VIN D (2005)
Notice: Refer to Fastener Notice in Service Precautions.
26. Tighten the support bracket to cylinder head.
^
Tighten the support plate to cylinder head to 10 Nm (89 inch lbs.).
27. Install the wing nuts and tighten.
28. Hold each camshaft in place using a 24 mm open end wrench and carefully remove the camshaft sprocket timing retaining bolts and washers.
Discard the Torque-To-Yield (TTY) bolts.
Important:
^
When sliding the timing chain and sprocket onto the guide pins, be sure the timing chain is positioned properly on the adjustable and fixed guide
or guide damage will occur. Care should be taken when removing the sprockets from the camshafts.
^
Camshafts are spring loaded and may rotate. Care should be taken until all spring tension is removed from the camshaft.
29. Slide the camshaft sprockets away from the camshafts.
30. To release the spring tension on the camshaft, after the camshaft is disengaged from the sprocket, rotate the camshaft using a 24 mm wrench to a
neutral position.
31. Uniformly loosen and remove the remaining camshaft bearing cap bolts.
