VUE FWD V6-3.5L (2008)
4. Coat the rocker arm friction surfaces using prelube. Refer to Adhesives, Fluids, Lubricants, and Sealers (See: Specifications/Adhesives, Fluids,
Lubricants, and Sealers) .
Important: Shims (P/N 88894006) may be required under the valve rocker arm pedestals if reconditioning has been performed on the
cylinder head or its components.
5. Install the valve rocker arms in their original positions.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
6. Install the valve rocker arm bolts.
Tighten the bolts to 34 N.m (25 lb ft).
7. With the NEW gaskets and seals in place, apply a small drop, 8-10 mm (.031-0.39 in) of RTV sealer to the 4 corners of the intake manifold to
engine block joints (1). Refer to Adhesives, Fluids, Lubricants, and Sealers (See: Specifications/Adhesives, Fluids, Lubricants, and Sealers) .
8. Install the lower intake manifold.
Notice: Maximum gasket performance is achieved when using new fasteners, which contain a thread-locking patch. If the fasteners are not
replaced, a thread locking chemical must be applied to the fastener threads. Failure to replace the fasteners or apply a thread-locking chemical
MAY reduce gasket sealing capability.
