VUE FWD V6-3.5L (2008)
Heat Shield: Service and Repair
Exhaust Manifold Heat Shield Replacement - Right Side
Exhaust Manifold Heat Shield Replacement - Right Side (LZ4-3.5L)
Removal Procedure
1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (See: Engine/Intake Manifold/Service and Repair) .
2. Remove the connector position assurance (CPA) retainer.
3. Disconnect the engine wiring harness electrical connector (3) from the heated oxygen sensor (HO2S) electrical connector (2).
4. Remove the HO2S electrical connector rosebud clip from the engine wiring harness retainer strap (6).
5. Remove the exhaust manifold heat shield bolts (1).
6. Remove the exhaust manifold heat shield (2).
Installation Procedure