VUE FWD V6-3.5L (2008)
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor Replacement - Bank 1 Sensor 2
Heated Oxygen Sensor Replacement - Bank 1 Sensor 2
Tools Required
J 39194-B Heated Oxygen Sensor Wrench
Removal Procedure
Notice: Refer to Heated Oxygen Sensor Resistance Learn Reset Notice (See: Service Precautions/Heated Oxygen Sensor Resistance Learn Reset
Notice) .
Notice: The oxygen sensor may be difficult to remove when the engine temperature is below 48°C (120°F). Excessive force may damage threads
in the exhaust manifold or the exhaust pipe.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
2. Remove the connector position assurance (CPA) retainer.
3. Disconnect the heated oxygen sensor (HO2S) electrical connector from the engine wiring harness electrical connector.
4. Remove the HO2S (3). Use the J 39194-B , if necessary.
Installation Procedure