seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Selector lever cable: removing and fitting (vehicles from 07.00 onwards)|Installation > < Selector lever cable: removing and fitting (vehicles from 07.00 onwards)

Leon Mk2

Removal
Removal
–  Disconnect the battery earth strap.
  Note!
For vehicles fitted with a coded radio, first check the anti-theft code.
–  Move the selector lever to “P”.
–  Removing the gear selector knob → Chapter.
–  Remove the trim sleeve.
–  Remove the cover frame of the selector lever with lever -U-30800-.
  Note!
Be careful with the edges of the frame as they are sharp and can cut
–  Removing the centre console: → Bodywork repairs, installation work, interior; Rep. Gr.68.
–  Move the selector lever to “N”.
   
–  Remove the selector lever cover by levering from the back and front -arrow 1- , and pull upwards -arrow 2- to remove.
–  Disconnecting the selector lever locking electromagnet connector.
  E37-0080
–  Remove selector lever cable ring -arrow-.
–  Release the selector lever cable from the bracket in the engine bay.
  E37-0081
–  Disengage the actioning cable by levering on the selector rod.
–  Remove the front part of the exhaust pipe with catalytic converter: → Rep. Gr.26
  N37-0930
–  Remove the exhaust system front bracket -arrows-.
–  Remove the front heat shield.
–  Release the selector lever cable from the bracket in the sub-frame.
–  Remove the cable from the protection box.
  E37-0077

Selector lever cable: removing and fitting (vehicles from 07.00 onwards)|Installation > < Selector lever cable: removing and fitting (vehicles from 07.00 onwards)