seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Assembly > < Neutral overrun spring: dismounting and assembling

Leon Mk2

Dismounting
Dismounting
  Note!
If the vehicle has a coded radio, first note down the code.
–  With the ignition disconnected, remove the ground strip from the battery.
–  Extract the objects-holder tray and the lower casing from the driver's side → Bodywork, assembly works; Rep. Gr.68.
   
–  Take out the bolts that attach the fuse box support to the dashboard.
–  Move the fuse box support downwards -arrow 1- and fix it into place in this position.
–  Extract the nuts that attach the relay plate by moving it carefully to the left.
–  Uncouple the clutch pedal from the control pump working rod → Chapter and press down the working rod to the stop in the direction of the engine housing.
–  Dismount the neutral overrun spring → Chapter.
  N30-0244
–  Take out the hexagonal nut -arrow 1- which attaches the pedal axle to the steering column.
–  Carefully remove the pedal axle -arrow 2-. Fix the brake pedal into its position at the same time with an M 8 bolt or a pin with the same Ø through the right hand side -arrow 1-.
–  Carefully move the pedal axle to the left, and try not to damage the electrical cables.
  Note!
Do not move the brake pedal or the steering column. They remain loose once the pedal axle has been extracted.
–  Remove the clutch pedal.
  N30-0082

Assembly > < Neutral overrun spring: dismounting and assembling