Leon Mk2
| Mechanism and working cables: dismounting and assembling; assembly chart |
Note!| Lubricate the support points and the sliding surfaces with grease -G 052 142 A2-. |
| 1 - | Cable for changing gears |
| q | Fit into the guide for the gear stick |
| q | Position for assembly → Chapter |
| 2 - | Cable for selecting gears |
| q | It is connected to the selection bracket |
| q | Position for assembly → Chapter |
| 3 - | Safety washer |
| 4 - | Safety washer |
| q | Do not damage the cables when dismounting it |
| 5 - | Protective box for the gear stick |
| 6 - | Support |
| 7 - | Hexagonal bolt, 25 Nm |
| q | For the support for the gear connection cables |
| 8 - | Hose |
| q | Housing for the support for the gear connection cables to the gearbox |
| 9 - | Separating piece |
| 10 - | Part for attaching the cable |
| q | In order to attach the cable for the gearbox to the return lever |
| 11 - | Part for attaching the cable |
| q | In order to attach the cable for the gearbox to the link rod for selection |
| 12 - | Return lever |
| q | Position for assembly → Chapter. |
| 13 - | Bearing sleeve |
| 14 - | Safety washer |
| 15 - | Guide block |
| 16 - | Selection linking rod |
| q | With counterweight |
| q | Put it into place in such a way that the uninterrupted division of the cogs matches the selection axle |
| q | Once it has been put into place, adjust the mechanism for working the gearbox → Chapter |
| q | Position for assembly → Chapter. |
| 17 - | Hexagonal nut, 25 Nm |
