SEAT Workshop Service and Repair Manuals

Mechanism for working the gearbox: adjust Special tools and workshop equipment required

t  Linchpin -T10027-   Note! t  In order to properly adjust the working for the gearbox , the following points must be taken into account: t  The gearbox, the working of the clutch and the clutch must all be in perfect working condition. t  The working of the gear change must be smooth and without difficulties. –  Place the gear stick into neutral.

–  Pull forwards, to the end, of the safety mechanism for the gear cables and for selection of gears -arrow 1- and block it into place by turning it to the left -arrow 2-. Fix the selector rod into place for adjusting it: by performing the following steps:

–  Push the gear stick downwards -arrow 1-. –  Turn and push the elbow -A- in the direction of the -arrow 2- until the rod its locked into place.   Note! In this position the inner end of the elbow -A- is housed in the gear stick by blocking it into the adjust position.

–  Remove the cover from the central console, by carefully moving it forwards. Fix the gear lever into place for adjusting it: by performing the following steps: –  Put the gear stick into the neutral position.

–  Place the linchpin -T10027- into the hole -B- through the hole -A-.   Note! In order to make it easy to put the tool -T10027- into place, move the gear stick until the two holes face each other.

–  Turn the safety mechanism for the gearbox cables and for gear se ection to the right in the direction of the -arrows-, up to the end. –  The spring presses the safety mechanism to the outlet position.

–  Turn the elbow -A- in the direction of the arrow, until returning it to its original position. –  Remove the linchpin -T10027- and assemble the cover for the gear stick on the central console.