Leon Mk2
| Assembly diagram - pedal bracket |
| 1 - | Support block |
| q | Removal: first remove the steering column to be able to remove the bracket → Running gear, axles, steering; Rep. Gr.48 |
| 2 - | Bolt |
| q | 25 Nm |
| 3 - | Nut, self-locking |
| q | 25 Nm |
| q | To secure the support block to the brake servo support bolt |
| q | Always renew |
| 4 - | Reinforcing |
| 5 - | Nut, self-locking |
| q | 25 Nm |
| q | Always renew |
| 6 - | Bearing bush |
| q | For locating the steering column |
| 7 - | Safety washer |
| q | Dismantling and fitting → Chapter, Clutch pedal: removing and installing |
| 8 - | Brake and clutch pedal shaft |
| q | Assembly position: the recess -arrow- should be on the clutch pedal side |
| 9 - | Brake pedal |
| 10 - | Clutch pedal |
| q | Dismantling and fitting → Chapter |
| 11 - | Housing |
| q | Remove → Fig. |
| q | Fitting → Fig. |
| 12 - | Clutch pump actioning rod |
| 13 - | Gasket |
| q | Always renew |
| 14 - | Allen head bolt |
| q | 22 Nm |
| q | Always renew |
| 15 - | Clutch pump |
| q | Dismantling and fitting → Chapter |
| 16 - | Circulation hose |
| 17 - | Safety washer |
| q | Dismantling and fitting → Chapter, Clutch pedal: removing and installing |
| 18 - | Bearing bush |
| q | Check for wear and renew if necessary |
| q | Remove with a drift |
| q | Fit it between the jaws of a vice |
| 19 - | Neutral overpass spring |
| q | Dismantling and fitting → Chapter |
