Leon Mk2
Gearbox drive mechanism couplings: repairing |
Note!
Lubricate all points of support and sliding surfaces with -G 052 142 A2- grease |
1 - | Securing pin |
2 - | Bearing bush |
q | Fit → Fig. |
3 - | Selector rod (short) |
q | Dismantling: open the tie with a screwdriver and separate the ball joints by levering with a screwdriver |
q | Install: fit in the ball joints with pliers and close the plastic tie |
4 - | Bolt |
q | To secure the coupling lever to the console |
5 - | Control rod |
q | With counterweight |
6 - | Nut, self-locking |
q | 20 Nm |
q | To secure the clip to the control rod |
7 - | Clip |
q | Assembly position: the notch on the clip should coincide with the projection guide on the gear stick |
8 - | Bolt |
q | To secure the clip to the control rod |
9 - | O- ring |
q | Renew if damaged |
10 - | Selector lever |
q | With heat shield. Cannot be replaced separately |
q | Assembly position of the heat shield → Fig. |
11 - | Control rod |
q | Remove it together with the gear stick, from the protective cover → Fig. |
12 - | Bolt |
q | 25 Nm |
q | Securing the support block to the steering box |
13 - | Support block |
q | Bearing bush for control rod. Cannot be replaced separately |
q | Dismounting and installation of the coupling shaft → Fig. |
q | Coupling shaft bush: Renew if damaged |
q | Coupling shaft bush: Fit → Fig. |
14 - | Selector rod (long) |
q | Dismantling: open the tie with a screwdriver and separate the ball joints by levering with a screwdriver |
q | Install: fit in the ball joints with pliers and close the plastic tie |
15 - | Return lever |
16 - | Bearing bush |
q | Renew if damaged |
17 - | Gear stick console |
q | It will not be necessary to remove it on removing the coupling lever |
18 - | Nut |
q | 15 Nm |
q | To secure the coupling lever to the console |
19 - | Nut, self-locking |
q | 25 Nm |
q | To secure the selector rod shaft to the gearbox |
20 - | Selector rod |
q | Only fits to the selector shaft in one position |
21 - | Gear change |
|
|