Leon Mk2
Note
|
| 1 - | Gearchange control cable |
| q | Fit into the gear lever guide |
| q | Installation position → Chapter |
| 2 - | Selection control cable |
| q | Port on deflection lever |
| q | Installation position → Chapter |
| 3 - | Securing washer |
| q | Always replace. |
| 4 - | Securing washer |
| q | Do not damage the cables when removing |
| 5 - | Lever protection box |
| 6 - | Counter support |
| q | May be plastic or metallic |
| 7 - | Elastic pin |
| q | For counter support on the gearbox |
| 8 - | Separator |
| 9 - | Hexagon bolt -2 Nm |
| q | For counter support |
| 10 - | Cable attachment |
| q | For selection control cable on idler lever |
| q | Replace after removal of the deflection cable |
| 11 - | Cable attachment |
| q | To secure selection control cable to idler rod |
| q | Replace after removal of the deflection cable |
| 12 - | Securing washer |
| q | will not be installed on plastic reversing lever |
| 13 - | Bearing bush |
| q | will not be installed on plastic reversing lever |
| 14 - | Idler rod |
| q | Installation position → Fig. |
| q | Once fitted, adjust the gear operation mechanism → Chapter |
| q | May be plastic or metallic |
| q | The plastic transfer lever is not equipped with bearing bushings -13- or retaining rings -12- |
| 15 - | Runner |
| 16 - | Selection rod with counter weight |
| q | With counter weight |
| q | Position so that the interrupted division of the teeth is adjusted to the selector rod |
| q | Once fitted, adjust the gear operation mechanism → Chapter |
| q | Installation position → Fig. |
| 17 - | 25 Nm self-locking hexagonal nut |
| q | Always replace. |
|
|
