seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fitting (clutch cable not tensioned) > < Removing

Leon Mk2

Fitting (clutch cable tensioned)
Fitting (clutch cable tensioned)
–  Pull the clutch cable through the bulkhead and fit the bellows.
–  Lubricate the clutch cable securing/clutch pedal area with -G 052 142 A2- grease.
   
–  Secure the clutch cable to the clutch pedal -arrow-. Replace the plastic tie that was cut when disassembling.
  V30-0397
–  Hook the clutch cable to the clutch release lever as described below:
–  Fit the rubber stop -3- into its location in the gearbox casing.
–  Pull the sleeve -2- in the direction of vehicle movement and fit the clutch cable into its location on the clutch release lever -1-.
  V30-0411
–  Secure the clutch cable to its location -arrow-.
  Note!
On securing the clutch cable to its location do not bend, otherwise the automatic adjustment mechanism could stop working properly.
  N30-0160
–  Remove the automatic adjustment mechanism tensioning cap -arrows-.
–  Checking the functioning of the clutch cable with automatic adjustment → Chapter
Once the functioning has been checked, continue assembly → Anchor
  E30-0064

Fitting (clutch cable not tensioned) > < Removing