SEAT Workshop Service and Repair Manuals

Cables and drive mechanism: removing and installing Special tools and workshop equipment required

t  Torque spanners -SAT 8010-

t  Extractor -U-40087-

1 -	Connection cable

q	Fitting position → Chapter

2 -	Track selection cable

q	Fitting position → Chapter

q	Fit before fitting the connection cable

3 -	Safety washer

4 -

Insulator

q	Remove and fit with a drift

5 -

Pin

6 -

Washer

7 -	Return lever

q	Remove the bracket before removing it → Chapter

q	Fitting position → Fig.

8 -	Selector rod

q	Fitting position → Fig.

9 -	Spherical head

10 -

20 Nm

q

Renew

11 -	Control finger

12 -

20 Nm

13 -	Safety washer

14 -	Bearing bush

q	For the selection rod

q	Remove the bracket before removing the bush

q	Remove → Fig.

15 -	Holding washer

16 -

25 Nm

17 -

Support

q	Removing and installing → Chapter

18 -	Bearing bush

q	For the coupling lever

q	Remove the bracket before removing the bush → Chapter

q	Remove → Fig.

q	It fits in only one position

q	Insert by pressure

19 -

Bolt

q	To secure the gearbox to the engine

q	Threaded for the counter-hold

20 -

Washer

21 -

Nut

q	Fit to the square side -arrow- in the selection rod

22 -	Selection rod

q	Remove the bracket before removing it → Chapter

q	Fitting position → Fig.

23 -

Washer

24 -

Insulator

q	Remove and fit with a drift

25 -	Combi bolt, 20 Nm

26 -

15 Nm

27 -

Bracket

q	To secure the counter-hold to the subframe

28 -

Washer

29 -

20 Nm

30 -	Countersupport

31 -

20 Nm

32 -

15 Nm

q	Self-locking

33 -	Rubber washer

Removing the selector rod bush-bearing

Removing the return lever bush-bearing

Assembly position of the connection rod, the return lever, selector rod, control finger 1 -  Control cable 2 -  Selector rod: it is inserted into the control finger -arrow- 3 -  Selector cable 4 -  Coupling lever 5 -  Support block 6 -  Control finger 7 -  Selector rod   Note! The counter-hold, for the control and selector cable is not show in the illustration.