Leon Mk2
|
|
|
|
|
Note!| t | Disconnect the battery earth strap |
| t | For vehicles fitted with a coded radio, first check the anti-theft code |
| t | Lubricate all articulations and contact surfaces with molybdenum grease (MoS2) |
| 1 - | Gear lever knob |
| q | Assign according to the Spares Catalogue |
| q | Mount → Chapter |
| 2 - | Attachment socket |
| 3 - | Clip |
| q | Fixing the knob and the cover to the gear lever |
| 4 - | Casing |
| q | Join to the gear lever knob before assembling |
| q | Mount → Chapter |
| 5 - | Frame |
| q | Removing the center console → General body repairs-assembly work, interior; Rep. Gr.68 |
| 6 - | Bearing bush for control rod |
| q | On fitting make sure that the two parts do not separate |
| 7 - | Control rod |
| q | Remove from the casing together with the gear lever → Fig. |
| q | Fit after assembling the gear drive |
| 8 - | Gear lever |
| q | Before removing, remove the excentric adjuster → Fig. |
| q | Before fitting the gear lever, fit the following elements: securing plate → Item, spring → Item and ball → Item and secure with pin → Item |
| 9 - | Plastic ring |
| q | Fit on the excentric adjuster groove |
| 10 - | Excentric adjuster |
| q | Fit onto the gear lever after fitting the lever |
| q | Remove → Fig. |
| 11 - | Screw |
| q | 2 Nm |
| q | To secure the excentric adjusters |
| 12 - | Pin |
| q | Removing and installing → Fig. |
| 13 - | Locking tab |
| q | Installation position → Fig. |
| 14 - | Hexagon nut |
| q | Self-locking |
| q | Always renew |
| 15 - | Spring |
| 16 - | Ball |
| 17 - | Spacer bush |
| 18 - | Ball support box |
| 19 - | Gasket |
| q | For the ball support box |
| 20 - | Rivet |
| q | To secure the stop |
| 21 - | Stop |
| 22 - | Plastic nut |
| q | To secure the central console to the selector box casing |
| 23 - | Spacer bush |
| 24 - | Gasket |
| q | Stick to gear lever protective cover |
| 25 - | Gear lever protective cover |
| q | Removing and fitting → Chapter |
| 26 - | Heat shield |
| 27 - | Hexagon bolt |
| q | 20 Nm |
| q | To secure the protection box to the bodywork |
| 28 - | Cross beam |
| 29 - | Hexagon nut |
| q | 20 Nm |
| q | Self-locking |
| q | Always renew |
| 30 - | Control rod |
| 31 - | Screw |
| 32 - | Clip |
| q | Loosen the bolt to remove the control rod |
| 33 - | Hexagon nut |
| q | 20 Nm |
| q | Fit after assembling the gear drive |
| 34 - | Angled finger |
| 35 - | Connecting shaft |
| 36 - | Connecting finger |
| q | Clean the threaded hole |
| 37 - | Hexagon bolt |
| q | 20 Nm |
| q | Always renew |
| 38 - | Bush |
| 39 - | Gasket |
|
|
|
|
|
|
