Leon Mk2
| Adjustment overview - rear final drive |
| If repairs have been carried out to the rear final drive, adjusting the shaft bevel gear, bevel gear or complete final drive gear set is necessary only if components having a direct effect on the adjustment of the final drive. To prevent unnecessary adjustments, refer to the following table: |
| To be adjusted: | |||
| Shaft bevel gear (S3) via deviation “r” → Chapter | Bevel gear (S1 and S2) → Chapter | ||
| Part renewed: | Pinion housing | x | |
| Rear axle housing | x | x | |
| Final drive gear set (Shaft bevel gear and bevel gear with stub shaft) | x | x | |
| Taper roller bearing for shaft bevel gear | x | ||
| Taper roller bearing for bevel gear with stub shaft | x | ||
| Cover (side of bevel gear with stub shaft) | x → Note | ||
| 1) | Adjust only S1 via previously measured total friction torque. |
