Leon Mk2
| Bearing housing: Assembly overview |
| 1 - | Bearing housing |
| q | Re-determine shim „S4“ when renewing → Chapter |
| 2 - | Outer race |
| q | For needle roller bearing on input shaft |
| q | Driving out → Fig. |
| q | Driving in → Fig. |
| 3 - | Shim „S4“ |
| q | Adjustment overview → Chapter |
| q | Re-determine when renewing bearing housing → Chapter |
| 4 - | Outer track, roller bearing |
| q | For output shaft |
| q | removing and fitting → Item |
| 5 - | Selector rod for 1st and 2nd gear |
| q | Only renew together with selector fork for 1st and 2nd gear (secured together by means of a pin) |
| 6 - | Selector rod for reverse gear |
| 7 - | Ball sleeve |
| q | (Front) for reverse gear selector rod |
| q | Remove → Fig. |
| q | Driving in → Fig. |
| 8 - | Ball sleeve |
| q | (Rear) for reverse gear selector rod |
| q | Remove → Fig. |
| q | Driving in → Fig. |
| 9 - | Selector rod for 3rd and 4th gear |
| 10 - | Selector rod for 5th and 6th gear |
| q | Remove burrs and scoring after removing from bearing housing |
| 11 - | Ball sleeve |
| q | For selector rod for 5th and 6th gear |
| q | Pull out with internal puller -Kukko 21/2- |
| q | Drive in until flush using guide pin -10 - 15- |
| 12 - | Locking bush |
| q | For selector rod for 3rd and 4th gear |
| q | Press and drive in → Fig. |
| 13 - | Locking bush |
| q | For selector rod for 5th and 6th gear |
| q | Press and drive in → Fig. |
| 14 - | Ball sleeve |
| q | For selector rod for 3rd and 4th gear |
| q | Pull out with internal puller -Kukko 21/2- |
| q | Driving in → Fig. |
