SEAT Workshop Service and Repair Manuals

Bearing housing: repairs Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter

Special tools and workshop equipment required

t	Clutch press -VW 402-, see equivalent → Anchor

t	Compression column -VW 408 A-, see equivalent → Anchor

t	Die -VW 412-

t	Thrust blocks -VW 454-

t	Installing sleeve -VW 455-

t	Tube element -VW 516-

t	Guide pin -10 - 15-

t	Thrust pad -3074-

t	-1-Interior extractor -Kukko 21/2-

t	-4-Support bracket -Kukko 22/1-

t	Mandrel -T40085-

Driving outer race for needle roller bearing out of bearing housing –  Clamp bearing housing in vice, using jaw protectors -C-. –  Drive out outer race -A- using drift -B- by alternately applying drift to the bearing housing recesses located opposite to each other -arrow-.

Pressing outer race for needle roller bearing into bearing housing until limit stop

Pulling front ball sleeve out of reverse gear selector rod A  -  Counter-support, e.g. -Kukko 22/1- B  -  Internal puller 14.5...18.5 mm, e.g. -Kukko 21/2-

Pressing front ball sleeve into reverse gear selector rod until limit stop. Fit ball sleeve -arrow- so that side with lettering (thicker metal) faces guide pin -10 - 15-.

Pulling out rear ball sleeve for reverse gear selector rod –  Clamp actuating arm of selector rod in vice, using jaw protectors -C-. –  Fit press tool -VW 454- and installing sleeve -VW 455- onto selector rod. A  -  Counter-support, e.g. -Kukko 22/1- B  -  Internal puller 14.5...18.5 mm, e.g. -Kukko 21/2-

Pressing in rear ball sleeve -A- for reverse gear selector rod

Driving in ball sleeve for selector rod for 3rd and 4th gear Fit ball sleeve so that side with lettering (thicker metal) faces guide pin - 10 - 15-. l  Dimension for pressing in -a- = 2.5 mm

Removing and installing locking bush for selector rod l  Remove the relevant selector rod (for 3rd and 4th gear or for 5th and 6th gear). l  Bolt bearing housing -B- with gearbox cover -A- onto gearbox housing prior to driving out and driving in the locking bushes -C-. –  Drive out the old locking bush inwards into bearing housing. –  Drive in new locking bush until flush.