Leon Mk2
| Assembly overview - „Sachs“ clutch |
| 1 - | Dual-mass flywheel |
| q | Removing and installing → Rep. gr.13 |
| q | Make sure that the centring pins have a tight fit. |
| q | Contact surface for clutch lining must be free of grooves, oil and grease |
| 2 - | Clutch plate |
| q | Allocation → Electronic parts catalogue „ETKA“ |
| q | Always replace together with the pressure plate |
| q | Removing and installing → Chapter |
| q | Installation position → Fig. |
| 3 - | Pressure plate |
| q | With adjusting mechanism |
| q | Renew only together with clutch plate. |
| q | Allocation → Electronic parts catalogue „ETKA“ |
| q | Removing and installing → Chapter |
| q | Check the ends of the diaphragm spring → Fig. |
| q | Check the elastic and riveted joints → Fig. |
| q | From approx. 05.11: clutch release with additional plastic washer → Fig., clutch plate is adapted → Fig.. |
| 4 - | M6 bolt, 13 Nm, M7 bolt, 20 Nm |
| q | Loosen and tighten diagonally in stages |
