Leon Mk2
| I - ATF pump to driving gear: general fitting diagram |
| 1 - | Bolt |
| q | 20 Nm |
| 2 - | ATF pump |
| q | Dismantling and assembling → Chapter |
| 3 - | Seal |
| q | For the ATF pump |
| 4 - | Brake strap -B2- |
| q | 2nd and 4th gear brake |
| q | Adjusting → Chapter |
| q | Place in installation position → Chapter |
| q | Place the piston thrust rod → Item and adjusting screw → Item into the moulded part of the brake strap |
| 5 - | Nut |
| q | 45 Nm |
| 6 - | Adjustment bolt |
| q | For brake strap -B2- |
| q | Always replace |
| q | Adjusting the brake strap → Chapter |
| 7 - | Shim |
| q | Determine the thickness of the shim by adjusting clutch clearance between -K2- and the ATF pump → Chapter |
| 8 - | Reverse gear clutch -K2- |
| q | Dismantling and assembling → Chapter |
| 9 - | Axial gear needle bearing |
| q | Note installation position → Chapter |
| 10 - | Clutch from 1st up to 3rd gear -K1- with turbine shaft |
| q | Dismantling and assembling → Chapter |
| 11 - | Axial gear needle bearing |
| q | Note installation position → Chapter |
| 12 - | Input shaft |
| 13 - | Axial gear needle bearing with washer |
| q | Note installation position → Chapter |
| 14 - | Drive pinion |
| 15 - | Drive pinion shaft |
| q | Disassembling and assembling → Chapter |
| q | The corresponding gearbox code is assigned to this spare part |
| 16 - | Gearbox casing |
| 17 - | Circlip |
| 18 - | Cover |
| q | With brake activating piston for 2nd and 4th gears |
| 19 - | Brake activating piston for 2nd and 4th gears |
| q | For brake strap -B2- |
| q | The corresponding gearbox code is assigned to this spare part |
| 20 - | Spring |
| 21 - | Spring |
