| General notes on adjustment of the sliding door |
Note | t
| All other available information such as, e.g. self-study programmes, multimedia programmes for dealership training and Technical Service Handbook entries must be used to provide assistance. |
| t
| Adjustment of the sliding door must be carried out with a great deal of care. |
| t
| For adjustment, vehicle must be resting on its wheels. |
| t
| The critical place is the rear upper corner of the sliding door towards the seal or trim strip of the side window. |
| t
| If both doors on one side have to be adjusted, the front door is preset with a dimension → Chapter |
| Sliding door has been correctly adjusted: |
| t
| if its gap is the same all round it when closed |
| t
| it is not protruding too far inwards or outwards |
| t
| the contours are flush with each other |
| t
| the striker pin of the sliding door does not rise or press down when door is closed |
| t
| and the sliding door does not come into contact with surrounding components when door is opened. |
| The sequence of the three work steps is as follows: |
| t
| Undo the screws of the locating peg, |
| t
| tighten the screws of the locating peg. |
|
|
|
