Leon Mk2
Removing and installing frame |
Special tools and workshop equipment required |
t | Window sealant pistol -SAT 5350- |
t | Cable holder knob -VAG 1351/1- |
t | Removal equipment -VAG 1474B- |
t | Window extraction kit -VAG 1755- |
t | Cartridge heater -VAG 1939A- |
t | Dual component window sealant -VAS 5237- |
Special tools and workshop equipment required |
t | Electric cutter -SAT 1561A- |
t | Scraper -SAT 1561/7+8- |
t | Knife 157 -SAT 1561/10- |
t | Knife 208 -SAT 1561/11- |
t | Knife 207 -SAT 1561/12- |
t | Blade 081 -SAT 1561/13- |
t | Counterhold -T10038- |
t | Lever -U 30800- |
t | Setting gauge -3371- |
t | Suction lifter -VAG 1344- |
|
Removing |
Note
The roof module is glued to the bodywork and, due to the second PUR cord, that is located the closest to the electric motor, destruction free removal is not possible. |
– | Remove windscreen → Chapter. |
– | Remove inner roof trim → Bodywork, interior assembly work; Rep. gr.70. |
– | From the inside the vehicle and using the electric knife -SAT 1561A-, cut through the bead of PUR adhesive bead attached all around the roof -2-. |
– | Remove the roof frame -1-. |
Installing |
– | When supplied as a spare part, the roof is packed with spacer blocks -3- which mark the depth of the frame in its position. |
Note
Use the tensioning strap -T10038- for pressing on and positioning the panorama roof after the adhesive cord of the dual component adhesive -DA 004 600 A2- has been applied. |
– | Around the entire perimeter -2- of the roof → Item, apply an adhesive cord of the dual component adhesive -DA 004 600 A2-. |
– | Fit the complete frame-1-, inserting the centring devices at the rear -4-. |
– | Minimum curing period → Chapter |
– | Refit all dismantled components |
– | Connect plug for drive unit. |
– | Mount glass cover → Chapter. |
– | Install the interior roof lining → Bodywork, interior assembly work; Rep. gr.70. |