seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Release unit of the folding backrest: Removing and installing > < Height adjustment element: Removing and installing

Leon Mk2

Lumbar support (manual, 2 possible positions): Removing and installing
Lumbar support (manual, 2 possible positions): Removing and installing
removing
–  Mount the holder for seat repair -VAS 6136- on the engine and gearbox jack -VAS 6095-.
–  Remove front seat → Chapter.
–  Fasten seat on seat repair stand -VAS 6136-.
–  Remove front belt buckle → Chapter.
–  Remove trim on tunnel side → Chapter.
–  Remove trim on sill side → Chapter.
–  Remove backrest → Chapter.
–  Mount backrest on seat repair stand -VAS 6136-.
–  Remove the adjustment lever of the lumbar support → Chapter.
–  Remove folding table on backrest → Chapter.
–  Remove front seat backrest cover and padding → Chapter.
   
–  Undo and remove the two screws -1- of the operating mechanism (1.5 ± 1 Nm).
–  Detach side fasteners -2- and -3- from backrest frame.
–  Detach springs at side.
–  Detach lumbar support -4- from upper mountings -arrows- in backrest frame.

Installation
–  Installation is carried out in reverse order.
   

Release unit of the folding backrest: Removing and installing > < Height adjustment element: Removing and installing