–
| Before setting rivet -4-, fit a plastic washer -1- between lumbar support -2- and backrest frame -3-. |
–
| Rivet lumbar support frame -2- to backrest frame -3-. |
–
| Pull out the plastic sheeting between backrest padding and lumbar support. |
–
| Fasten Velcro strip of lumbar support to backrest padding. |
–
| Connect electrical connectors to longitudinal and height adjustment lumbar support motors. |
Perform remaining installation in reverse order of removal. The following must be taken into account: |
WARNING Before handling airbag units (for example to attach the connector), the person concerned must „discharge static“, for example by briefly grasping hold of door striker plate. |
|
Note Make sure electrical connectors are correctly fitted and engage with a click. |
WARNING The battery must be connected with the ignition switched on. If pyrotechnic components (e.g. airbag or belt tensioner) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle while you are connecting the battery. |
|
–
| Connect battery with ignition switched on. For procedure, refer to → Rep. gr.27. |
|
|
|