SEAT Workshop Service and Repair Manuals > Leon Mk2 > Body | Bodywork - Interior fitting work | Seat frames | Front seat with manual adjustment | Modular wiring routing using a corrugated tube on the front seat: Removing and installing | Modular wiring routing using a corrugated tube on the front seat: Install

Modular wiring routing using a corrugated tube on the front seat: Install

Installation is carried out in reverse order. The following must be taken into account:

WARNING

t	Observe the safety precautions for working on airbags → Chapter.

t	Before handling airbag units (for example to attach the connector), the person concerned must „discharge static“, for example by briefly grasping hold of door striker plate.

–	Take care not to twist any wires when bunching the individual wires and fitting them in the corrugated tube.

Note

Note the correct installation position of the two-piece corrugated tube in relation to the wiring harness and the cable retainer.

–	The start of the corrugated tube -4- should be positioned immediately after the clip -2- / cable tie.

3 -	Wiring harness to connector point

–	Make sure the two-piece corrugated tube -4- is properly closed over its entire length.

–	Make sure side -arrow A- of cable retainer -1- follows on immediately from last bead -arrow B- of corrugated tube -4-.

–	Bind self-adhesive fabric tape -arrow- around the transition between the corrugated tube on the seat end -1- and the wiring harness -2-.

–	Take care to first engage lugs -arrows A- of cover panel -1- properly in mountings -arrows B- of connector point -2-.

–	The cover panel can only be clipped to the connector point if properly engaged.