| Tray compartment: Install |
| Installation is carried out in reverse order. The following must be taken into account: |
WARNING | t
| Observe the safety precautions for working on airbags → Chapter. |
| t
| Before handling airbag units (for example to attach the connector), the person concerned must „discharge static“, for example by briefly grasping hold of door striker plate. |
|
Note | Make sure electrical connectors are correctly fitted and engage with a click. |
WARNING | The battery must be connected with the ignition switched on. If pyrotechnic components (e.g. airbag or belt tensioner) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle while you are connecting the battery. |
|
| –
| Connect battery earth wire with ignition switched on → Rep. gr.27. |
| –
| If the airbag warning lamp -K75- indicates a fault, use the vehicle diagnostic, testing and information system -VAS 505X- to read-out, erase and then re-read the fault memory. |
|
|
|
