SEAT Workshop Service and Repair Manuals

Storage compartment: Disassembling and assembling Dismantle the storage compartment. –  Removing storage compartment → Chapter Removing trim

–  Using the disassembly tool -3409-, remove the trim -1- from the retainer tabs -arrow- (4x) of the lower area -2-. Removing handle with locking mechanism –  Remove decorative trim → Anchor.

–  Pull the shaft -1- out of lower area -3-. –  Detach handle with locking mechanism -4-, torsion spring -2- and shaft -1-. Remove cover   Note t  The cover is fitted to the lower area without using any additional fasteners. t  For displaying reasons, neither the trim nor the handle with locking mechanism are shown in the illustration. –  Open storage compartment.

–  Pull the cover -1- out of lower area -2-. Separate the lower area from the outer section –  Open storage compartment.

–  Press the lugs -2- (2x) upwards in direction of -arrow A-. –  Fold down the lower area -1- in the -direction of arrow B-.

–  Remove the outer section -1-along the guide -arrow- of the lower area -2-. Assembling storage compartment Assemble in reverse order. The following must be taken into account:

–  Hang in the torsion spring -1- so that the shorter end -arrow A- rests on the lower area -2- and that its longer end -arrow B- rests on the handle -3-.