SEAT Workshop Service and Repair Manuals

Removing and installing C-pillar trim, 2-door models Special tools and workshop equipment required

t  Torque wrench kit -SAT 8010-

t  Release lever -T20043-

t  Release lever -U30800- Removal   Note Removal and installation on the left side of the vehicle are is described. Releasing and securing on the right side of the vehicle is similar. –  Remove the rear tray. –  Remove seat bench → Chapter. –  Fold down rear bench seat backrest on left side.

–  Partially remove the side trim -1- in the direction of the -arrow- in order to be able to access screw -2-. –  Unscrew the bolts -2- and -3-. –  Loosen the luggage compartment trim -4- from the fasteners of the clips -5- using the lever -T20043-. –  Detach luggage compartment trim -4-.

–  Unscrew bolt -1- and remove belt bracket -2- from body.

–  Release the trim -1- from the mounts -2- using the lever -T20043- and remove from the trim. –  Guide the seat belt through the D-pillar trim opening. Installation   Note t  Before installing, check all fasteners for damage and renew if necessary. t  Ensure that C-pillar trim is correctly inserted in retaining clips. t  Following installation, ensure that trim is positioned in door seal beading. Installation is carried out in the reverse order. When installing, note the following: Tightening torques

Scews for the buckle

40 Nm