| t
| If an undamaged glass is re-used, a little before gluing reduce the sealant residue leaving only 1 or 2 mm, without damaging the primed layer nor the ceramic layer. |
| t
| In the case of the rear window, cut the sealing glue remaining on the edges, on the left and right hand side, lifting it towards the centre of the glass. In this way, it will be easier to apply the new sealing glue |
| t
| The residual material will act as an adherent base for the new sealing glue |
WARNING | The sticking contact surface should not be treated with primer or cleaning solution. The sticking contact surface must be kept free of dirt and grease. |
|
| Exception: if gluing is not finished immediately after lowering the residual adhesive cords then the existing residual material must be activated, using the activator |
|
|
|
