seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Sliding roof > < Door lock with operating elements: repair

Leon Mk2

Door lock: removal and fitting
Door lock: removal and fitting
Removing
The corresponding door window should be closed.
–  Dismantle the door handle
–  Remove the lining of the door → Lining of the rear door: removal and assembly; Rep. Gr.70.
   
–  Move the interior operation handle -1- in the opposite direction to travel -arrow- and take it out of the fastening openings.
–  Unhook the rod -2-.
–  Release the soundproofing sheet → Door soundproofing sheet: removal and fitting; Rep. Gr.70.
  N57-0117
–  Remove the pressure hose -1- from the activator (only for vehicles fitted with central locking system). Remove the clips -2- fastening the safety rod.
  Note
The hoses should be inserted up to 1.5 cm in the hose connections.
–  Sink the pin into the bent lever -3-. Remove the bent lever from the door and unhook the safety rod.
–  The pin should be removed from the door (rattling noise on refitting the elements).
  N57-0139
–  Loosen the bolts of the window guide support -1- and unhook the door.
–  Extract the bolts -2-.
t  Tightening torque: 8 Nm
–  Remove the lock from the assembly hole by lifting upwards and disengage the operating rod and the safety rod from the door lock.
  N57-0140

Sliding roof > < Door lock with operating elements: repair