SEAT Workshop Service and Repair Manuals

Selector lever cable: Adjusting to basic setting Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter Special tools and workshop equipment required

t  Socket and key -T40031- Operation process –  Remove selector mechanism cover → Chapter. –  Shift selector lever to position „D“.   Note

Before adjusting the selector lever cable to basic setting make sure that clamping bolt has been tightened. The clamping bolt can be accessed via the hole in the selector mechanism, when in position „D“. Use socket and key -T40031- to tighten clamping bolt. –  In this position, tighten the clamp bolts using the socket -T40031- (tightening torque: 13 Nm) is located behind the plug. –  Shift selector lever into position „P“.

–  Open quick release fasteners -2- and -3- and take off rear noise insulation.

–  Remove the holder for the selector lever cable -1-. Unscrew bolt -2- for this purpose.   Note Make sure the selector lever is in position „P“.

–  Press the selector shaft lever -A- on gearbox towards the rear as far as it will go until the parking lock engages.   Note t  Item -B- can be disregarded. t  When the parking lock has engaged it should no longer be possible to rotate both front wheels in one direction at the same time. –  Make sure that the selector lever cable has not been bent or kinked and that it is not under tension. –  Make sure that the selector lever cable has been fixed tight to the support bracket with the counter nut using the respective tightening torque → Item.

–  Tighten the securing screws -2- of the bracket of the selector lever cable -1- to the respective tightening torque → Anchor. –  Adjust selector lever cable → Chapter. Tightening torque

Component	Nm
Clamping bolt to selector lever cable	13
Bracket on the gearbox	23