seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Renewing oil seal for selector shaft > < Selector lever control cable: and adjusting
Check the ignition key withdrawal lock
   
Check the ignition key withdrawal lock
                            
   Start                     
                           
                
                          
 
–  Put the gear selector lever into position „P“
–  Switch off ignition.
–  Take out the ignition key.
  Faulty gear selection mechanism or steering lock.
–  Read the fault memory using the vehicle diagnostic, testing and information system -VAS 505X-
–  Replace the faulty parts
       
                          
               no           
                          
 Can the selector lever can only be moved from position „P“ when the button is pressed?YesIncorrectly adjusted selector lever cable?Yes
–  Adjusting selector lever cable → Chapter
 
                          
     no                     
                          
   Correct functioning                   
                          
                          
 
–  Insert the ignition key
–  Press in the brake
–  Switch on ignition
       


      
                          
 Can the selector lever can only be moved from position „P“ when the button is pressed?no

      
                          
                          
     Yes                     
                          
 
–  It should be possible to shift selector lever to „R, N, D or S“
     
           
                          
 Can the ignition key be removed?Yes no     
                        
     no
–  Press in the brake
–  Put the gear selector lever into position „P“
The ignition key can be removed and the gear selection lever is locked in position „P“ 
                           
                      Yes     
                           
                  Ignition key removal lock OK 
                            

   

Renewing oil seal for selector shaft > < Selector lever control cable: and adjusting