seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing the joint between dashboard and floor > < Outer air turbine V2 and base plate: separation

Leon Mk2

Removing and refitting the dust and pollen filter
   
Removing and refitting the dust and pollen filter
1 - Filter frame
2 - Dust and pollen filter, or aspiration
3 - Plastic nut, 3,6 Nm
4 - Washers
5 - Filter housing, with seal
Removing
–  Take off the rubber seal and the water box protection, right hand side.
  E80-0006
–  Remove the wind deflector trim - A- from the dust and pollen filter.
–  Pull the dust and pollen filter -C- upwards and take out of the housing -B-.
  A80-0078
Fitting
–  The moving part -A- of the cover of the water channel must not be supported on the dust and pollen filter.
–  The dust and pollen filter must be fitted on the proper side in the assembly frame -B-. The etched arrows -A- show the direction of the air flow.
–  This filter must be changed regularly. → Booklet
  A80-0079

Removing the joint between dashboard and floor > < Outer air turbine V2 and base plate: separation