seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and fitting the evaporator > < O-Rings for the refrigerant circuit

Leon Mk2

Components of the manual air conditioning (Climatic)
Components of the manual air conditioning (Climatic)
Additional information:
t  → Current flow diagrams, Electrical fault finding and Fitting locations
t  → Air conditioning with refrigerant R134a; Rep. gr.00
Observe notes on control and regulation of components located in passenger compartment → Chapter.
  Note
t  The air duct in the air conditioning and in the vehicle is the same for all systems (heating, Climatic, Climatronic) → Chapter.
t  Air conditioning: removal and installation is the same for both systems (Climatic, Climatronic) → Chapter.
   
1 - Air conditioning unit with evaporator
q   This may only be removed when the refrigerant circuit is empty; bring the vehicle to a support workshop specialised in air conditioning work
q   Removing and installing air conditioning unit → Chapter
q   Air conditioning: dismantling and assembling → Chapter
q   Removing and installing evaporator → Chapter
2 - Heat exchanger for heater
q   Detaching and attaching → Chapter
3 - Temperature flap control motor -V68- with potentiometer for temperature flap control motor -G92-
q   Detaching and attaching → Chapter
4 - heater element for additional air heater -Z35- with Additional air heater control unit -J604-
Installed in vehicles with diesel engine.
Installed in vehicles 11-2011▶ with petrol engine 1.2 TFSI.
q   See → Current flow diagrams, Electrical fault finding and Fitting locations
q   Checking operation → Vehicle diagnostic tester
q   From 11/06 it has been replaced by two relaysHigh temperature relay -J360- and Low temperature relay -J359-, see → Current flow diagrams, Electrical fault finding and Fitting locations
q   Removing and installing (Removing and installing) -Z35-, vehicles ► 11.2006 → Chapter
q   Removing and installing (auxiliary air heater control unit) -Z35-, vehicles 11.2006 ► → Chapter
q   Removing and installing (auxiliary air heater control unit) -Z35-, vehicles 11.2006 ► → Chapter
5 - Servomotor for air recirculation flap -V113-
q   Detaching and attaching → Chapter
6 - Intake duct with air recirculation and air-flow flap (fresh-air flap)
q   Detaching and attaching → Chapter
7 - Fresh-air turbine -V2-
q   Detaching and attaching → Chapter
8 - Dust and pollen filter
q   Detaching and attaching → Chapter
q   Heed replacement intervals → Booklet101
9 - Coolant pipes going to heat exchanger
10 - Grommet
q   To make airtight the passage for the refrigerant tubes and cooling agent in the transverse panel to the engine compartment
11 - Connection for condensation drain
q   Checking condensation drain, removing and installing condensation drain hose → Chapter
12 - Expansion valve
q   Detaching and attaching refrigerant pipes → Chapter
q   Detaching and attaching → Chapter
13 - air temperature sender, evaporator -G263-
q   Detaching and attaching → Chapter

   

Removing and fitting the evaporator > < O-Rings for the refrigerant circuit