t
| The condensation drain valve -C- has no flap. |
t
| In the event of moisture problems in the passenger compartment, check the following components in addition to the condensation drain: |
t
| the correct fitting of the plenum chamber cover and the cover for the air inlet opening, also check for damage → Chapter. |
t
| the correct fitting of the dust and pollen filter and if it is dirty → Chapter. |
t
| the forced ventilation vents in the boot → Chapter. |
t
| the signal for detecting windscreen wiper operation Air conditioning control unit -J301-, Climatronic control unit -J255- → Vehicle diagnostic tester. |
t
| Check the temperature of the air leaving the evaporator using the measurement value of the Air temperature sender, evaporator -G263- in the conditions of use described by the client, or the operating conditions of use described below in the Air conditioning control unit -J301-, Climatronic control unit -J255- → Vehicle diagnostic tester. |
t
| Select the lowest temperature possible for the passenger and driver side |
t
| If the measurement value of the sender is too low (for an atmospheric temperature above 0°C, less than 0°C for a long period of time) or too high (even if the air conditioning functions correctly above about 10°C, for example), see the notes for the refrigeration performance test → Chapter. |
|
|
|