seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Clearance between pulley and drive plate: verifying and adjusting > < Pulley: removing

Leon Mk2

Pulley: fitting
Pulley: fitting
–  Assemble in reverse order; neverthless, note the following instructions:
  Note
   
t  Replace the circlip -A-.
t  Ensure that the circlip -A- is correctly seated in the groove in the compressor bracket.
t  Clean the compressor bracket before fitting the pulley; it should be quite easy to fit the pulley in position. (Fitting should be completed without having to apply any significant force).
t  Take special care when fitting the circlip -A- that it is not bent any more than is necessary for fitting.
t  Fit the circlip -A- on the correct side, the side with the insertion rebate -C- should be on the side facing away from the compressor (the flat side faces the compressor).
  A87-0499
t  There are different versions of the pulley -C- and the drive plate -A-, for this reason, note the type carefully. → Parts catalogue
  A87-0498
t  Replace the bolt -A- (fitted with fixing agent).
t  Use the bolt you removed -A- to adjust the clearance.
t  Fit the drive plate -B- for the clearance setting, first with 2 distancing washers, and hand tighten the bolt -A-. Then check the clearance → Chapter.
t  Only place the new bolt -A- after establishing the clearance (due to the threat fixing agent) and tighten to 20 Nm.
  E87-10001

Clearance between pulley and drive plate: verifying and adjusting > < Pulley: removing