Leon Mk2
| Installation overview for the air conditioning unit |
| 1 - | Preliminary resistance for the fresh air fan -N24- |
| q | Removing and fitting → Chapter |
| 2 - | Control motor for fresh air and circulating air flap -V113- |
| q | With integrated potentiometer -G143- |
| q | Removing and fitting → Chapter |
| q | Check → Vehicle diagnosis, testing and information system VAS 5051 |
| 3 - | Fresh-air fan -V2- |
| q | Removing and fitting → Chapter |
| 4 - | Dust and pollen filter |
| q | Also as a combined filter with the odour filter |
| q | Removing and fitting |
| 5 - | Flexible shaft |
| q | For the air distributor flap regulation unit (colour: blue, length 250 mm) |
| q | Removing and fitting → Chapter |
| 6 - | Heating and air conditioning control |
| q | Assembly overview → Chapter |
| q | Replace completely |
| q | Removing and fitting → Chapter |
| 7 - | Connect for the output temperature sender, floor compartment -G192- |
| 8 - | Output temperature sender, floor compartment vent -G192- |
| q | To remove it, it is necessary to remove the dashboard and turn the sender 90° to the left. |
| q | Check → Vehicle diagnosis, testing and information system VAS 5051 |
| 9 - | O-rings |
| q | Replace if it has defects. |
| 10 - | Heating elements for the secondary heating (PTC) -Z35- |
| q | Only in some vehicles |
| q | Installation overview |
| 11 - | Heat exchanger |
| q | Installation overview |
| q | Removing and fitting → Chapter |
| 12 - | Regulating motor for temperature flap -V68- |
| q | With integrated potentiometer -G92- |
| q | Removing and fitting → Chapter |
| q | Check → Vehicle diagnosis, testing and information system VAS 5051 |
| 13 - | Gasket with support |
| q | Fit with a clip to the heating unit |
| q | Replace if it has defects. |
| q | Installation position in → Fig. |
| 14 - | Valve for the condensation water outlet |
| q | Mount together with the support → Item on the air conditioning unit. |
| 15 - | Connector for the evaporator outlet temperature sender -G263- |
| 16 - | Evaporator outlet temperature sender, centre -G191- |
| q | Mounted on the intermediate part for the dashboard nozzle |
| q | To remove it, it is necessary to remove the dashboard and the intermediate part. Turn the sender 90° to the left. |
| q | Check → Vehicle diagnosis, testing and information system VAS 5051 |
| 17 - | Evaporator outlet temperature sender -G263- |
| q | To remove it, it is necessary to remove the dashboard and extract it laterally. |
| q | Check → Vehicle diagnosis, testing and information system VAS 5051 |
| 18 - | Oil seal |
| q | Replace if it has defects. |
| 19 - | Support |
| q | For cooling the storage tray in the glove box |
| q | Screwed onto the housing |
| 20 - | Connection pipe |
| q | Towards the storage tray in the glove box |
