seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Control unit for heating and fresh air connectors > < Removing

Leon Mk2

Fitting
Fitting
  Note
t  There are transmission gears fitted on the main board for the heating controls and in the heating system. Rotating the air distribution control makes the flexible shaft rotate twice.
t  Due to the fact that when the dashboard is fitted the flap positions cannot be seen, take into account the air distribution flap positions when connecting the flexible shaft to the main board.
   
–  Connect the Bowden cable for the temperature flap to the main board -A-.
–  Assemble the main board -A- and the control unit -B- → Chapter.
  E80-10009
–  Fit the rotating control -D- into position so that the flexible shaft -C- can be inserted into the allotment on the main board -A-.
  E80-10009
–  Insert the flexible shaft -C- onto the main board -A-
–  Fit the rotating control -D- into the position “foot well air distribution” (as shown in the diagram).
–  Check the position of the flap in the area of the right hand side foot well -E-, the air duct -F- must be completely open.
–  If the air duct -F- is closed:
–  Release the flexible shaft -C- from the main board -A-.
–  Turn the rotating control -D- to the position “air distribution to the windscreen”.
–  Insert the flexible shaft -C- onto the main board -A-
–  Fit the rotating control -D- into the position “foot well air distribution” (as shown in the diagram).
–  Check the position of the flap in the area of the right hand side foot well -E-, the air duct -F- must be completely open.
Continue fitting in the reverse order of removal operations.
  E80-10009

Control unit for heating and fresh air connectors > < Removing