Leon Mk2
| Gearbox casing and 5th gear cover: removing and installing |
| 1 - | M8×62 hexagon bolt |
| q | 25 Nm |
| q | 4 units |
| 2 - | M8×85 hexagon bolt |
| q | 25 Nm |
| q | 2 units |
| 3 - | Gearbox casing and 5th gear cover |
| q | Repairing → Chapter |
| 4 - | Syncromesh assembly for 5th gear with stop ring |
| q | Dismantling and assembly → Chapter, Input shaft: dismantling and assembling |
| 5 - | Safety ring |
| q | Renew |
| 6 - | Thrust washer |
| 7 - | Locking tab |
| q | The gearboxes with this tab do not fit positions 5 and 6 |
| 8 - | 5th gear |
| q | Assembly position: with the groove facing upwards |
| 9 - | Safety plate |
| q | Renew |
| q | Removing and fitting → Chapter |
| 10 - | Fork for 5th gear |
| q | Adjusting → Anchor |
| 11 - | M17 bolt |
| q | 150 Nm |
| q | Renew |
| q | Apply -D 000 600 A2- to the new bolt |
| q | Removing and fitting → Chapter, Assembly sequence |
| 12 - | Gasket |
| q | Renew (if fitted) |
