Leon Mk2
hydraulic system: Assembly overview |
1 - | Brake fluid deposit |
2 - | Spring clip |
q | Not fitted in all vehicles |
3 - | Circulation hose |
q | Different versions: made from rubber and from plastic → Fig. |
4 - | Master cylinder |
q | Removing and installing → Chapter>>>>>>>> |
5 - | Clip |
q | To remove and install pipe/hose assembly, pull out clip as far as it will go |
6 - | Mounting |
q | To remove and install retaining clip first detach master cylinder from clutch pedal. → Chapter |
7 - | Clutch pedal |
q | Removing and installing → Chapter>>>>>>>> |
8 - | Hexagon nut → Item |
9 - | Seal / O-ring |
q | Pull onto line connection |
q | Lubricate with brake fluid before installing |
q | Seals/O-rings are adapted to configuration of line connection → Fig. |
q | Allocation → Electronic parts catalogue „(ETKA)“ |
10 - | Pipe and hose assembly |
q | Allocation → Electronic parts catalogue „(ETKA)“ |
q | Removing and installing → Chapter>>>>>>>> |
11 - | Spring retainer |
q | Fixed onto the bodywork |
12 - | Seal / O-ring |
q | Pull onto line connection |
q | Lubricate with brake fluid before installing |
q | Seals/O-rings are adapted to configuration of line connection → Fig. |
q | Allocation → Electronic parts catalogue „(ETKA)“ |
13 - | Clip |
q | To remove and install pipe/hose assembly, pull out clip as far as it will go |
14 - | Slave cylinder |
q | Removing and installing → Chapter>>>>>>>> |
15 - | Hex bolt → Item |
16 - | Vent valve |
q | Bleed the clutch system → Chapter. |
17 - | Grease cap |
18 - | Gearbox: |
19 - | Spring retainer |
20 - | Hexagon bolt, 20 Nm |
|
Item | Material of line connection |
1 | Line connection with circumferential groove -arrow 1- |
2 | Line connection with shoulder -arrow 2- |
3 | Line connection with shoulder -arrow 2- and circumferential groove -arrow 3- |
|
|