Install in reverse order but note following: |
t
| Pump securing bolts at 20 Nm + 90° |
t
| Alternator support securing nuts at 30 Nm |
t
| Pulley securing bolts at 20 Nm |
t
| Alternator securing bolts at 25 Nm |
–
| Fill the refrigerating circuit. |
Note! In versions without tensioning roller, once the Poly-V belt ifs fitted and before tightening the alternator securing bolts, it is necessary to turn the engine at idling (approx. 10 seconds); then tighten the alternator securing bolts (lower bolt first). |
|
|
|