Leon Mk2
| Part I |
| 1 - | 20 Nm |
| 2 - | Tensioning lever |
| 3 - | Tensioning roller |
| 4 - | Dust cap |
| 5 - | Expansion clip |
| 6 - | Upper toothed belt guard |
| 7 - | Toothed belt |
| q | Removing and installing → Chapter |
| q | Mark D.O.R. before removing |
| q | Check for wear |
| q | Do not kink |
| 8 - | 45 Nm |
| 9 - | Eccentric |
| 10 - | Tensioning roller |
| q | Checking: → Chapter |
| 11 - | 45 Nm |
| 12 - | Camshaft sprocket |
| q | Remove the camshaft cone with a tap of a hammer and drift through the hole in the toothed belt guard |
| 13 - | 25 Nm |
| 14 - | Idler roller |
| 15 - | 10 Nm |
| 16 - | Rear toothed belt guard |
| 17 - | Injection pump sprocket |
| q | Monopart |
| 18 - | Injection pump |
| q | Removing and installing: → Rep. Gr.23 |
| 19 - | Support |
| 20 - | Console |
| 21 - | Intermediate shaft pulley |
| 22 - | Crankshaft sprocket |
| 23 - | 90 Nm + 1/4 turn (90°) |
| q | Remove and install with tool -T20018A- |
| q | Renew |
| q | Lubricate the thread and the collar |
| 24 - | 55 Nm |
| 25 - | Lower toothed belt guard |
| 26 - | Pulley for coolant pump |
| q | Versions with Poly-V belt |
| 27 - | Ribbed belt |
| q | Mark direction of rotation before removing |
| q | Removing and installing → Chapter |
| 28 - | Belt pulley/vibration damper |
| q | Can only be installed in one position -holes are offset |
| 29 - | Toothed belt |
| q | Adjust the tension of the trapezoidal belt → Chapter |
| 30 - | Pulley |
| q | For the coolant pump |
| q | For trapezoidal belts |
| 31 - | Pulley |
