seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Compression values > < Test condition

Leon Mk2

Test process
Test process
–  Remove the middle connector of the pump injectors.
–  Remove the connectors from the glowplugs.
–  Remove all the glowplugs with spanner -U-40082-.
   
–  Thread adaptor -V.A.G. 1381/12- into glowplug holes.
–  Test the compression with the compression gauge -V.A.G. 1763-.
  Note!
Use of the tester → Instructions for use.
–  Activate the starter motor until the tester no longer shows an increase in pressure.
  N15-0292

Compression values > < Test condition