SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 3-cylinder diesel engine with pump injector unit, mechanics | Engine cooling | Removing and installing parts of cooling system

Removing and installing coolant pump

t	Removing → Anchor

t	Installing → Anchor

Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Collecting tray -T20173-, see equivalent → Anchor

t	Base -T20174-, see equivalent → Anchor

Removing

Note

First replace seals and gaskets.

–	Drain coolant → Chapter.

–	Remove poly V-belt → Chapter.

–	Remove toothed belt → Chapter.

–	Unscrew the attachment bolts -1- from the coolant pump -2- and take out the liquid coolant pump very carefully.

Installing

Continue the installation in the reverse order of removal sequence, observing the following:

Note

Renew O-ring.

–	Clean or smoothen the contact surface for O-ring.

–	Moisten new O-ring -3- with coolant.

–	Fit the cooling liquid pump -2- to the engine block and tighten the attachment bolts -1- to a torque of 15 Nm.

Note

The coolant pump plug faces downwards.

–	Install toothed belt → Chapter.

–	Install poly V-belt → Chapter.

–	Fill up coolant → Chapter.

SEAT Workshop Service and Repair Manuals