| t
| When installing the bearing cap note offset, before installing camshaft fit bearing caps and determine fitting position. |
| –
| Oil camshaft running surfaces. |
| –
| Tighten bearing caps 2 and 4 alternately and diagonally to 20 Nm. |
| –
| Install bearing caps 5, 1 and 3 and also tighten to 20 Nm. |
| –
| Locate bearing cap 5 by tapping lightly on the end of the camshaft. |
| –
| Install camshaft sprocket. |
| –
| Install and tension toothed belt → Chapter. |
Note! | When new tappets have been installed the engine must not be started for about 30 minutes. Hydraulic compensation elements must settle (otherwise valves will strike pistons). |
|
|
|
