Leon Mk2
| Crankshaft: removal and refitting |
| 1 - | Semibearings 1, 2, 4 and 5 |
| q | Fit caps without a lubrication groove |
| q | For engine blocks with lubrication grooves |
| q | Do not swap the worn semibearings (mark them) |
| 2 - | 65 Nm + 1/4 turn (90°) |
| q | Replace |
| q | To measure the radial play, tighten to a torque of 65 Nm, but do not retighten |
| 3 - | Caps |
| q | Cap 1: Pulley side |
| q | Cap 3 with edges for drive washers |
| q | The lips of the semibearings of the engine block must line up with those of the caps |
| 4 - | Semibearing 3 |
| q | For caps without lubrication grooves |
| q | For engine blocks with lubrication grooves |
| 5 - | Drive washer |
| q | For cap 3 |
| q | Note the fixing |
| 6 - | Generator wheel |
| q | For speed transmission |
| q | Replace if worn |
| 7 - | 10 Nm + 1/4 turn (90°) |
| q | Replace |
| 8 - | Pin |
| q | Check the protuberance of the pin above the crankshaft → Fig. |
| 9 - | Crankshaft |
| q | Axial play, new: 0.007…0.017 mm |
| Wear limit: 0.37 mm |
| q | Measure the radial play with Plastigage |
| New: 0.003…0.08 mm |
| Wear limit: 0.17 mm |
| q | Do not turn the crankshaft when measuring the radial play |
| q | Crankshaft measurements → Chapter |
| 10 - | Drive washer |
| q | For engine block, bearing 3 |
|
|
