Leon Mk2
| Thermostat side |
| 1 - | Support |
| q | For central connector |
| 2 - | Self-tapping bolt |
| q | 10 Nm |
| q | Maximum speed of the power tool: 350/min |
| 3 - | From bottom of radiator |
| q | → Item |
| q | Coolant hose connection diagram → Chapter |
| 4 - | Connection sleeve |
| 5 - | O-ring |
| q | Renew |
| 6 - | Coolant thermostat |
| q | Checking operation: Heat thermostat in water The thermo element pin should move out. |
| q | Temperature check: Opening commences (approx. 84 °C) and ends (approx. 98 °C) not possible |
| 7 - | Toward the expansion tank |
| q | → Item |
| q | Coolant hose connection diagram → Chapter |
| 8 - | Toward the heat exchanger |
| q | Coolant hose connection diagram → Chapter |
| 9 - | From expansion tank |
| q | → Item |
| q | Coolant hose connection diagram → Chapter |
| 10 - | Securing clip |
| q | Check for secure seating |
| 11 - | From heat exchanger |
| q | Coolant hose connection diagram → Chapter |
| 12 - | Coolant pump housing on cylinder block |
| 13 - | O-ring |
| q | Renew |
| 14 - | Coolant pipe |
| 15 - | Thermostat housing |
| 16 - | 10 Nm |
| 17 - | Coolant temperature sender -G62- |
| q | For engine control unit |
| q | With coolant temperature gauge sender -G2- |
| q | If necessary, release the pressure in cooling system before removing |
| 18 - | Cap |
| q | If necessary, release the pressure in cooling system before removing |
| 19 - | Toward the top of radiator |
| q | → Item |
| q | Coolant hose connection diagram → Chapter |
